ACTEL / MICROSEMI FPGA Programmer
20 €
+ Versand ab 4,89 €Beschreibung
**Low-Cost Programming Stick (LCPS)**
Interface
The development board can be programmed by the low-cost programming stick (LCPS) or via a 10-pin FP3 header (Figure
4-24). Regardless of the programming dongle used, IGLOO PLUS is programmed the same way as IGLOO nano, ProASIC3, and Fusion FPGA devices.
The LCPS is a special version for the FlashPro3 programming circuitry that is compatible with FlashPro3 and the generic FlashPro programming software.
The LCPS, like the IGLOO PLUS board, is RoHS-compliant and is completely lead (Pb) free. To use the LCPS with the FlashPro software, all you need to do is to select the FlashPro3 from the list of programmer types.
The LCPS behaves exactly as if it were a regular encased FlashPro3 programmer, except regarding VPUMP. The LCPS does not supply VPUMP; it must be supplied by the IGLOO PLUS board. The 12-pin female connector socket is designed to interface to the 12-pin rightangle male header on the IGLOO PLUS kit. One of the pins is a special VJTAGENB signal that goes high when programming is taking
place and returns to a low level when programming has completed. This signal is connected to the FET on the 1.5 V
regulator circuit. The IGLOO PLUS board uses this signal to
effect a change in the value of VCC from 1.2 V to 1.5 V, which is required for programming all IGLOO PLUS devices.
You do not need to have the LCPS connected to the IGLOO PLUS board to operate it, after the FPGA has been programmed.
The LCPS must be connected to the IGLOO PLUS board only when programming the AGLP125-CSG289.
---------------------------
Verkauf als Privatperson, ohne Rücknahme und ohne Gewährleistung.
